Started the passengers side floors. This pic is the floors the PO put in it. They were just flat metal welded in and were rusting out.
Cut out the "new" floor and look... there's the old floor they didn't bother cutting out.
So I did it right and cut it out... didn't understand why you would have left them in if they were crap but whatever.
Pic of my little (not so much anymore) helper.
The "correct" floors thanks to NPD. Had to trim about 1/2" off the forward side because it was hitting the ducting and that was it. Perfect fit no complaints at all. I will do some welding today if I have enough gas for the MIG. If not I will cut out the drivers side and wait till I get some cash on Friday.
No comments:
Post a Comment